You are here: Mast climbing platforms / MCP 1500

GEDA MCP 1500

This appliance can be operated from the platform only by way of dead man's handle. You can stop at any point in order to start working from the platform.

The mast climbing platform is equipped with an overload overstress device that switches off the travelling motion in both directions, if 110% of the maximum load capacity is reached.

If the platform (double mast) inclines more than 2° while operating, the upward/downward motion of the respective actuation shuts down. It continues after the platform has been aligned horizontally.

If the platform (double mast) inclines more than 5°, the safety catch device of the actuation below engages and brings the platform to a halt.

Every driving unit includes an error-analyzing device with a diode that shows the engine's status.

Since an electric horn is sounded when the platform moves downwards, the mast climbing platform may be operated without additional protection device.

Technical data:

• Carrying capacity 1500 kg
• Lifting speed 9 m/min
• Platform width: max. 16,2 m
• Fastening distance (vertically): max. 10 m
• Maximum projecture of mast length: 5 m
• Maximum mounting height: 100 m
• Length of mast element: 1,5 m
• Weight of mast element: 40 kg
• Lifting speed (400V/50 Hz):: 9 m/min, (480V/60Hz): 10,8 m/min
• Releasing speed for safety catch: ca. 20 m/min

Two base units are required, each including:

• Foot section with four adjusting spindles and base mast 2,0 m
• Sledge with actuation 3,0 kW/400 V/50 Hz and speed-dependent safety catch
• Safety stop 2 m above ground with audible danger signal
• Operating and emergency limit stop above and below
• Controls with key switch and electrical socket 230V
• Overload stop with display
• Starting clamp for emergency shutdown switch